|
|
|
Kit include PX02 compressor, AT02-3 6 litre tank, 70 to 100psi pressure switch, relay, braided hose, check valve, flare fitting and drain tap.
Compressor is the PX02 12 volt, 1/4 hp, 1.25cfm free flow, 50% duty cycle, recommended working pressure 0-150psi, max pressure 200psi, 1/4npt port head, built in air filter, crankcase fed design, max amp draw 25 amps start up under load, oil free design, quite running, rebuildable design, 3 mounting holes with rubber grommets.
1.0 CFM at 150 psi
Rotatable head
Not rebuildable
NB: Must use check valve to prevent back flow
Never oil this compressor.
Tank is the AT02-3 lightweight T6 heat treated aluminium air tank with 3 ports. Tank is made from one piece extruded alumium centre section and stamped alumium end caps that are then robot welded together for consistent quality. Tanks are shot blasted, heat treated and anodised. Working pressure 0psi to 160psi, tested to 480psi. Meets or exceeds AS4343-2005 standard.
Tank can be mounted on end, upright or upside down while maintaining drain port at the bottom.
Tank dimensions approx. 800mm long, 150mm high, 100mm wide
NB: Maximum working pressure is 160psi.
|
